Alphatech Fermax IP DP Installation Guide download pdf (Page 21)

IPDP - installation and operating instructions

3 Programming of Parameters

3.1 Basic VoIP settings

3.1.1 Choosing a mode and login

It is important to choose a DoorPhone mode

first. The DoorPhone can work in the PeerToPeer

mode or SIP server mode. The mode setting can be

made by a relevant switch (DIP switch see on Pict. 9).

In the SIP server mode is possible to choose SIP

server (external). It can be set in a configuration

interface of the DoorPhone.

Setting values in doorphone to the firm setting

make by DIP switch 3 move to the position off and

reboot doorphone. After reboot system this switch is

necessary return to the position On.

Setting of basic IP address

192.168.1.250 make by DIP switch 4

move to the position off and reboot

doorphone. After reboot system this switch is necessary return to the position

On.

Reboot doorphone it is possible make by double ways – partly turn it off

and on again, or clicks on „Restart", in WEB site is at the entry service.

IP address of doorphone is from the manufacturer (as well as default)

setting on 192.168.1.250. If you are at installation in other numbering nets (=

NOT BEGINING 192.168.1.xxx) so is necessary setting in feature of protocol

TCP/IP in your PC IP address either temporarily or like alternative configuration

e.g . 192.168.1.245 . Then it is possible setting parameters of doorphone

including new IP address and after reboot VoIP module in doorphone you can

attach to WEB sites of the doorphone already on new IP address.

ATTENTION: DIP switch 3 and 4 must be in position "On", otherwise new IP

address after reboot module is re-write back on starting IP address =

192.168.1.250.

Pict. 1 DIP switch setting

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 37 38

No comments

Alphatech Fermax IP DP Installation Guide Page 21