Alphatech Fermax IP DP Installation Guide download pdf (Page 14)

IPDP - installation and operating instructions

pushbuttons can be found on the basic electronics module (the main PCB).

In case you use a panel without these first two pushbuttons, then please

leave them out during the programming process (pushbuttons 1 and 2).

5. Visit card. The exchange of visit card is described later on in the manual.

The visit card is illuminated by white LEDs (they can be switched off). You

can also find a red LED under the visit card – it is used for signallisation of

the door phone panel status.

6. Microphone.

1.4.4 Exchange of visit cards

The visit cards are disassembled from the front of

the door phone panel as shown on the picture.

Please use a tool carefully, do not damage the

front panel or the cover of visit cards. The cover

of visit cards is a tub into which you place the

paper with descriotion (the visit card).

1.4.5 Camera

The module of colour camera is

integrated into the panel of Fermax by a

sub-board with mounted LED illumination

and a sensor of surrounding light.

1. Camera module

2. The main board of the camera - 3

LEDs for illumination

3. Mounting column for the main board

4. Sensor of surrounding illumination

5. Mounting of the main board

1.4.6 Expansion module Fermax PBX EXP

The expansion module has got two connectors 5, one is used for connection

towards the basic module (Fermax PBX DP)

and the second one is used for connection

of the following module. For interconnection

please use cable Fermax PBX CC5.

Besides connectors 5, you can also find on

the expansion module the connector 8 for

connection of the pushbuttons. For

interconnection please use the cable

Fermax PBX CC8. Each colour of the

cable is assigned exactly to the specific

pushbutton, see picture for more details.

Picture 4 Cable Fermax PBX CC8

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

No comments

Alphatech Fermax IP DP Installation Guide Page 14