Alphatech Fermax IP DP Installation Guide download pdf (Page 16)

IPDP - installation and operating instructions

1.4.7 Keypad module Fermax PBX KEY

The keypad module is connected via a cable Fermax PBX CC5 and a cable

Fermax PBX CC3. The connection is similar to the connection of the expansion

module. The difference is that the keypad module is always the last in the row

(you cannot connect to the keypad module any other module). The keypad

module can be only connected to the second position (i.e. directly to the basic

module) or to the third position (to the output of the first Fermax PBX EXP

module). Attention – 1st position can´t be used because the first position

is occupied by the fixed expansion on the basic module (pushbuttons 3-

10). This means that besides the keypad you can use 0 – 18 pushbuttons with

the direct dialling (depends on the specific configuration).

Please pay attention during programming – you need to specify correctly to

which position the keypad is connected.

Dialling is realised by a sequent pushing of number

pushbuttons. When entering a password, you need to press

the B pushbutton. To hang up, please press the pushbutton

A and the door phone panel hangs up.

1.4.8 Other modules (panels)

All other panels can be found in the offer of your local partner.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 37 38

No comments

Alphatech Fermax IP DP Installation Guide Page 16